How to rebuild disc array and logical drive

  • 148 Views
  • Last Post 05 June 2018
Al Lippman posted this 01 June 2018

I have a pegasus2 R6 12TB.

Drive 6 went bad and I replaced it. I now need to rebuild the Disk Array (degraded 12TB 0 byte enabled # of LDs 1) and the logical drive(critical 10TB raid5 strip 1 MB array of 0).

 

Order By: Standard | Latest | Votes
Raghuraman Kannan posted this 01 June 2018

Hi,

Please follow the below steps to start the rebuild on the drive.

 

- Make sure you hot-plug the new drive.

- Click on "Physical Drive" list in the Utility and make sure the replacement drive is showing up in the list .

- The status of that drive should be "Unconfigured" .

- If the status is "Passthru", then unlock the Utility and click on settings for that drive and change it to "Unconfigured".

- Confirm the settings ..

- Then click on "Background Activities".

- Click on the Start button next to the Rebuild.

- Select the Source drive and the Target drive and Start the process.

- It will take sometime to complete the process and you can see the progress in the bottom.

 

Thanks !

  • Liked by
  • Pradeep Chidambaranath
Al Lippman posted this 05 June 2018

Just followed your direction and after 10 hours all is fine.

Thanks

Close