How to rebuild disc array and logical drive

  • 317 Views
  • Last Post 05 June 2018
Al Lippman posted this 01 June 2018

I have a pegasus2 R6 12TB.

Drive 6 went bad and I replaced it. I now need to rebuild the Disk Array (degraded 12TB 0 byte enabled # of LDs 1) and the logical drive(critical 10TB raid5 strip 1 MB array of 0).

 

Order By: Standard | Latest | Votes
Al Lippman posted this 05 June 2018

Just followed your direction and after 10 hours all is fine.

Thanks

Raghuraman Kannan posted this 01 June 2018

Hi,

Please follow the below steps to start the rebuild on the drive.

 

- Make sure you hot-plug the new drive.

- Click on "Physical Drive" list in the Utility and make sure the replacement drive is showing up in the list .

- The status of that drive should be "Unconfigured" .

- If the status is "Passthru", then unlock the Utility and click on settings for that drive and change it to "Unconfigured".

- Confirm the settings ..

- Then click on "Background Activities".

- Click on the Start button next to the Rebuild.

- Select the Source drive and the Target drive and Start the process.

- It will take sometime to complete the process and you can see the progress in the bottom.

 

Thanks !

  • Liked by
  • Pradeep Chidambaranath
Close