I have a E630f, which previously had SATA drives in it, and I'm swapping out to larger capacity SAS. Is there any reason that the array wouldn't recognize or spin up a SAS drive? The firmware on the array is quite old, and I'm planning to upgrade it to see if that has anything to do with it, but I can't think that would have much to do with it, since it's just making an electrical connection to the drive. I've removed the SATA Blackjack adapter on a few of the drive sleds (the array still "knows" about the previous SATA drives in its config, which I'm also going to revert to factory), but when I put in a SAS drive back in the array, the drive lights just don't even come on. Plugging the drive sled out, the drive doesn't appear to have been spining, either (no rotational momentum).
Ideas? What should I do next?