Pegasus Promise R6 connection issue after upgrade to Mac OS 27

  • 41 Views
  • Last Post 5 hours ago
Derek Cadzow posted this 17 hours ago

My Pegasus Promise R6 had been working flawlessly for the past 16 years.  

I have it connected to a Mac Mini Server 2011/Yosemite and this combination serves the two laptops in the house over the wireless network and it works very well.  Until yesterday...

I upgraded one of the laptops to Mac OS 27 and it wouldn't connect any more.  I pursued the issue on the net and on AI and discovered that Apple has discontinued AFP, which eliminated any possibility of connection in the old manner. Strangely enough, the screen sharing app still worked.

I converted the connection to SMB per the recommendations I found. This restored the network connection to the Mac Mini, and I could see the top-level file folders on the Pegasus in the MacBook's finder.  However, clicking on any of those folders does not show the contents in the next column -- it just shows that large folder icon as if the permissions were not set right.

I went back to the Mac Mini/ Pegasus and made sure all the permissions were set correctly.  But no change to the result.

On the Pegasus, I also updated one utility and one firmware update (the only ones pending) and no change to the result.

I've read that there may be a driver update (for the Mac?) that helps the Pegasus connect through SMB to Apple silicon?  Can anyone advise on that or offer some advice for the issue?

Thanks,

Derek 

Order By: Standard | Latest | Votes
Frank Bosma posted this 9 hours ago

Hey Derek,

the Pegasus is a direct attached storage block device.
It's controller only presents any created logical drive to the connected host as a single ISCSI disk over the Thunderbolt port.
It has no access to any partitions, filesystems or data on the disks, there for it is not possible to connect to it via SMB or any other form of network sharing.
I assume the mentioned folders do show the content normally on the Mac Mini server itself ?

Kind regards,
Frank

  • Liked by
  • Derek Cadzow
Frank Bosma posted this 9 hours ago

I found some useful tips to check with Claude AI.
See attached .pdf file

Attached Files

  • Liked by
  • Derek Cadzow
Derek Cadzow posted this 7 hours ago

Thanks Frank, I appreciate the information.  Until OS 27, the set up worked fine.  The Pegusus shared the files across all computers on the network and, since it was RAID 5 protected, we used it to keep a number of critical files for our household including fnancial data and our lightroom photo libraries.  So perhaps the AFP setup is not technically considered network sharing, but it worked.  Unfortunately I did not know that AFP had been deprecated so long ago.

From the Mac Mini, all files on the Pegasus are still viewable of course becuase nothing has changed there.

I had already reset all the permissions for folders on the Pegasus/Mini and that didn't seem to make any difference.

Plugging the Pegasus directly into the Mac wiith OS 27 does not work either --- so a direct connection seems to suffer from the same malady.  That seems to indicate that moving the DAS to a newer Mac wouldn't sofve the issue.

Finances will make acquisition of a new NAS a non-starter and, at this point I'm considering simply downgrading the Macbook and capping it permanenly at Mac OS 26.

I'll try the other Claude proposals this morning and see what happens. I'm usually leery of custom fixes as many times those can be eliminated by other updates. But if those work, I'll let you know!

Thanks once again, I appreciate the quick response and your wisdom more than you know!  : )

Frank Bosma posted this 6 hours ago

The Pegasus device should be able to connect to a new Apple silicon Macbook with OS27 without any issues.
Of course you will need a Thunderbolt 2>3 adapter to physically connect it and it requires installation of the DEXT driver for the Pegasus32 model (which is backward compatible with the older Pegasus hardware).
This knowledgebase article describes the installation and approval of the DEXT driver in newer MacOS systems.

  • Liked by
  • Derek Cadzow
Derek Cadzow posted this 6 hours ago

Thanks Frank, I'll give that a go. I presume that would allow me to attach the Pegasus directly to the Mac OS 27 machine, but would it allow sharing those files on the Pegasus to other computers across our network?  From what you said eariler, it sounds as if with SMB, that would not be possible?

Or is it the case that because the files are being shared from one computer to the another through file sharing (rather than being distributed across the network directly from the Pegasus) that this would still work?

Derek Cadzow posted this 6 hours ago

Also, asking Claude about this: 

Yes, it would still work. Your second guess is right.

Why Frank’s two statements don’t conflict

The Pegasus has never shared anything over the network by itself. It’s just a big disk. The Mac it’s plugged into does the sharing. For 16 years that was the Mac Mini, using AFP. Frank meant that nothing on the network can connect to the Pegasus directly. A Mac sharing a drive that’s plugged into it is ordinary file sharing, and macOS 27 supports it over SMB.

So if you plug the Pegasus into the macOS 27 MacBook and turn on File Sharing there (System Settings > General > Sharing), the other laptop can reach it over SMB, the same way it used to reach the Mini. Any Mac from 2013 on supports SMB, so that part is fine.

The catch is that the MacBook becomes your server. Whenever it’s closed, asleep or out of the house, nobody else can get to the files.

A correction to your forum post

The direct connection didn’t fail because of the same problem. It failed because the Promise driver wasn’t installed. Apple Silicon Macs don’t include it, which is the point Frank is making. Once the driver and the Thunderbolt 3 to Thunderbolt 2 adapter are in place, a newer Mac should see the Pegasus fine. Moving it to a newer Mac is still a real option.

Options, cheapest first

  1. Today: install the driver and connect the Pegasus to the MacBook. Even if this isn’t the permanent setup, it gives you direct access. Back up the financial files and anything else critical before you change anything else.
  2. Upgrade the Mac Mini from Yosemite to High Sierra. It’s free. Frank’s notes say High Sierra is as far as a 2011 Mini can go, and its SMB server is three years newer than Yosemite’s. It may fix the network problem while keeping your current setup with the Mini as the server. Two cautions: back up the Mini first, and check that the Promise utility and driver support High Sierra on that machine. This might not work, but it costs nothing to try.
  3. Downgrade the MacBook to macOS 26. This is still possible, but I’d make it the last resort. Once the MacBook is held at 26, it eventually stops getting security updates. That matters on the machine you use for financial files.

About custom fixes: I share your caution, but the nsmb.conf file in Frank’s notes is a standard Apple settings file and not a hack. Updates don’t usually remove it, and deleting it with one command undoes it completely.

My suggestion is to start with option 1 today. Once your important files are safe, you can try option 2 without pressure.


Derek:  the bottom line for me is this statement: "The catch is that the MacBook becomes your server. Whenever it’s closed, asleep or out of the house, nobody else can get to the files."

So the connection to the laptop is only a stop-gap solution. Another fix, I suppose, would be to upgrade the Mac Mini to a more modern one and hope the connection would "just work" that way?

Claude:  

Yes. A newer Mac Mini as the server is the real long-term fix. It wouldn’t be completely plug-and-play, but it’s close.

Why it should work

The Pegasus is fine. The weak link is Yosemite’s 12-year-old file sharing. A newer Mini running a current macOS would share the Pegasus over modern SMB, which is what macOS 27 expects. You’d keep the same setup you’ve had for 16 years: the Mini stays on, the Pegasus is attached, and both laptops connect over Wi-Fi.

Setup you’d still need to do

  • A Thunderbolt 3 to Thunderbolt 2 adapter, as Frank mentioned.
  • On an Apple Silicon Mini, Promise’s DEXT driver, installed and approved.
  • File Sharing turned on, with the Pegasus folders and user accounts added.

Test it with the MacBook before you buy anything

You can prove the whole setup works without spending money on a Mini:

  1. Install the driver on the MacBook, plug in the Pegasus with the adapter, and confirm you can see your files.
  2. Turn on File Sharing on the MacBook and connect from the other laptop.

If both steps work, a newer Mini will work the same way, because the MacBook is standing in for the Mini. That also turns the stop-gap into a dress rehearsal. And if something fails, you’ll know before you’ve spent anything.

What to look for in a Mini

Any Apple Silicon Mini (M1 or later) will do, and a used or refurbished one keeps the cost down. You don’t need much power to serve files. Avoid older Intel Minis: they’ll stop getting macOS updates sooner, and you’d be back in this situation in a few years.

The free option comes first

Upgrading the current Mini from Yosemite to High Sierra costs nothing. It might be enough to get you through until a new Mini fits the budget. Back up the Mini first and check that Promise supports High Sierra before you upgrade.

So the plan in order: install the driver on the MacBook and copy your critical files off. Then try High Sierra on the old Mini. Buy a newer Mini only if High Sierra doesn’t fix it.

Frank Bosma posted this 5 hours ago

Yes, that about sums it up correctly :-)

An update of the OS on your Yosemite server could solve the issue for now.
The Pegasus system and software is fully compatible with High Sierra.
If you connect the Pegasus to your up to date Macbook you can use that one as a network share server (like you currently use your Mac Mini) to access the Pegasus disk from other connected network devices.

  • Liked by
  • Derek Cadzow
Close