Vtrak E610S will not boot - PBL_RAM

  • 364 Views
  • Last Post 06 July 2021
Dan Harms posted this 05 July 2021

I've got a Vtrak E610S that had a few dead drives. Could not gain access to it. One drive was swapped and the whole unit started to reboot. It's been trying to boot up but no luck. Used hyper-terminal to monitor boot up and it gets to "Restarting subsystem. Please wait", then starts over (PBL_RAM). I'm wondering if the controller is shot or...

Looking through script, I also see 

Unable to handle kernel NULL pointer dereference at virtual address 00000000

pgd = 40004000

[00000000] *pgd=00000000

Internal error : Oops : 17 [#1]

R P posted this 06 July 2021

Hi Dan,

From the sound of it. it's most likely a bad controller.

Close