SanLink 2 Thunderbolt 10gb Network interface unit no longer works (detected but no DHCP address received and manual configuration does not achieve network connectivity)
SanLink 2 Os X10.13 beta no DHCP address
- 217 Views
- Last Post 04 September 2017
Damon Davies
posted this
12 June 2017
Dinesh Kannusamy
posted this
12 June 2017
Hi Damon,
We do not have a beta driver, please try the below solution to disable VT-d and update us.
Steps:
1. Go to the Recovery Mode ( Reboot the Mac and hold down Command + R )
2. Open terminal in “Utilities”
3. Type “csrutil disable”
4. Reboot the Mac
5. Open the terminal in Mac
6. Add dart=0 into boot-args with below command:
sudo nvram boot-args=”dart=0”
7. Reboot the Mac
Regards,
Dinesh.K
Damon Davies
posted this
13 June 2017
Good Afternoon,
Thanks for your reply, I did try it...no go still no dhcp or when even I try a manual address still fails on my SANLink2 10G SFP+
Dinesh Kannusamy
posted this
13 June 2017
Hi Damon,
We need more information to narrow down the issue, please create a web support case in support.promise.com.
OR
You can also reach our Tech support:
https://promise.com/ContactUS/Detecting
Regards,
Dinesh.K
Alex Geis
posted this
04 September 2017
Also having the same issue here. Created a support ticket as well.
