I recently acquired à Pegasus32 R6, everything is running fine for the moment except one little thing i don't understand.
The R6 shut itself down when i shutdown my computer (a PC actually) but when I boot it up again the R6 does not mount automatically. And I feel that it was the case in the first weeks of use.
Everyday when i boot up I have to disconnect and connect again the thunderbolt cable so it shows up in Windows Explorer. I tried all different port and different cables but none are working.
Is it the way it's meant to work ? Is there a settings I need to activate ?
Thanks for your reply.
Pegasus32 R6 not mouting on windows boot
- 188 Views
- Last Post 17 October 2020
Could you check the power saving level of the Pegasus32, if it's 0 then try to change it as 3.
Use below kb link as reference for chaning the powersaving level:
If still have an issue, then kindly reach us through support.promise.com
- All Categories
- General Discussion
- Atlas Family
- Apollo Cloud Family
- VTrak Family
- Vess Family
- FileCruiser Family
- Pegasus Family
- SANLink Family
- Legacy Product