Pegasus3 r4 powers off?

  • 918 Views
  • Last Post 08 October 2026
G Mat posted this 07 October 2026

Hi there, my R4 unit has started powering off. if i remove all drives, it powers on.. no warning lights/ issues.. but if i put any drives back in from a cold start or hot swap it turns off. 

Order By: Standard | Latest | Votes
R P posted this 07 October 2026

Hi G,

Boots with no disks and shuts down with disks inserted, the most likely cause is that the power supply has gone bad.

Promise does not have replacement power supplies but if you search the forum threads there are a few threads where people have found replacement power supplies (and provided links) and some warnings to make sure you have the proper input voltage selected.

G Mat posted this 08 October 2026

Have tried a different power suply, but unfortunatly the same issue prevails. open to any other suggestions anyone may have. 

R P posted this 08 October 2026

Hi G,

Please try this...

Power the Pegasus down
Unseat all drives but PD1
See if it the Pegasus shuts down

Repeat with only PD2 seated, then PD3...

With only one drive seated this is safe, but do not leave multiple drives seated.

It's possible that one of the drives is so bad that it takes the Pegasus down with it. So far I have only seen the case where a bad drive caused the Pegasus to fail to boot, I have not seen it cause a shutdown.

 

G Mat posted this 08 October 2026

Hi again, 

I've tried taking all out drives and putting 1 in at a time.. starting with top.. working way down to see if its an isolated drive.. but ANY single drive in any slot kills it. 

Close