Hello, I have a Pegasus R4 drive in RADI 5. The disk number 4 had failed. The red light is on and the application says that its DEAD.My question is can I replace it with any brand of 2Tb drive?Is there any special procedure for replacing the drive to ensure that I keep my data intact?
Pegasus R4 Disk failure
- 1.2K Views
- Last Post 02 June 2019
Paul de Carte
posted this
29 October 2016
- Last edited 29 October 2016
Dinesh Kannusamy
posted this
29 October 2016
Hi Paul,
In case if the drive has any errors like (Bad Sectors, Command times out, PFA, SMART) then please replace it with a same capacity(2TB) drive listed in Promise compatiblity list and before you start Rebuild please make sure the Logical Drive status is set to Critical and then you can Hotplug the new drive which will initiate the Auto rebuild on the replaced drive.
Below is the Compatibilty list for Pegasus R4 unit:
http://www.promise.com/DownloadFile.aspx?DownloadFileUID=4127
For more information you can also call Promise Tech Support on 408-220-1500.
Thanks..
Paul de Carte
posted this
02 June 2019
Hello,since my last post in which I replaced the HD and everything has been fine until today when the number 4 drive failed again. I have looked for the same model Hitachi 2T drive but it looks as if this drive has been discontiuned. In the compatibility list are drives of 3 and 4T. I dont know if these can be mixed with a 2T system. Can you surgest a 2T drive thats compatibile.
Thanks
