Hej Guys,
looking for a solution to stop the autostart of our Promise.
We would start the iMac without starting the R6. If we need the Promise 2 we would like to start it with the power-button.
Any solutions for us?
Thanks!
How to deactivate the autostart of the Promise 2 R6 on a Mac?
- 110 Views
- Last Post 16 November 2017
Paten Orfi
posted this
16 November 2017
Dinesh Kannusamy
posted this
16 November 2017
Hi Paten,
You can achive this by disabling the Power management feature in the Pegasus unit. Please use the below KB for more information.
https://kb.promise.com/thread/how-do-i-turn-off-all-hard-disk-drive-power-management-features-of-pegasus2/?order=all#comment-01b8682b-5f2c-4737-bf6a-a5b6009dcbc7
For any further assitance please contact Promise Tech support https://promise.com/ContactUS/ Or create a web support ticket in support.promise.com
Thanks..
Joe Engledow
posted this
16 November 2017
- Last edited 16 November 2017
Hi,
The power management feature only controls the power management of the hard drives in the Pegasus.
In order to stop the Pegasus2 from turning on when you turn on the Mac, you would need to disconnect the Thunderbolt cable. Once you connect the Thunderbolt cable, the Pegasus2 will turn on.
If the Thunderbolt cable is disconnected, the Pegasus2 will shut down 30 seconds after being powered on with the power button.
